Intended Use; Technical Data; Declaration Of Conformity; Noise/Vibration Information - Bosch PSR 10,8 LI-2 Originalbetriebsanleitung

A complete overview of accessories can be found in our
accessories program.

Intended Use

The machine is intended for driving in and loosening screws
as well as for drilling in wood, metal, ceramic and plastic.
The light of this power tool is intended to illuminate the power
tool's direct area of working operation and is not suitable for
household room illumination.

Technical Data

The technical data of the machine are listed in the table on
page 71.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with all rele-
vant provisions of the directives 2009/125/EC (Regulation
1194/2012), 2011/65/EU, 2014/30/EU, 2006/42/EC in-
cluding their amendments and complies with the following
standards: EN 60745-1, EN 60745-2-1, EN 60745-2-2.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
70764 Leinfelden-Echterdingen, GERMANY
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
10.10.2014

Mounting and Operation

Action
Removing the battery
Inserting the battery
Mounting application tools
Reversing the rotational direction
Setting the torque
Selecting the drilling position
Gear selection, mechanical
Switching On and Off
Selecting Accessories
Bosch Power Tools
Helmut Heinzelmann
Head of Product Certification
PT/ETM9

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 71.
Sound emission values determined according to
EN 60745-2-1.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure
1
2
3
4
5
6
7
8
–
English | 11
Page
72
72
72
73
73
74
74
74
75
1 609 92A 0UX | (28.10.14)