Electrolux SANTO 72390-6 KA Benutzerinformation Seite 71

3. Remove the door.
4. Unscrew the pin of the bottom
hinge (f) and refit it on the
opposite side.
5. Unscrew the pin of the upper hinge
(d) and refit it on the opposite side.
6. Insert the door in the upper hinge
and refit the upper hinges (A).
Pay attention that the border of the
doors are parallel to the top border,
otherwise adjust the position of
the lower hinge of the door (A).
7. Remove from the ventilation
grille the cover (e) and refit it on
the opposite side.
8. Refit ventilation grille.
9. Unscrew the handle. Refit it on
opposite side after having pierced
he plugs with a punch. Cover the
holes left open with the plugs
contained in the documentation
pack.
Reposition, level the appliance,
wait for at least one hour and
then connect it to the mains socket.
In any case you do not want to
carry out the above mentioned
operations, contact the nearest
After Sales Service Force. The
After Sales Service specialist will
carry out the reversibility of the
doors at your cost.
Attention:
After having reversed the opening direction of the doors check that all the
screws are properly tightened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may
not fit perfectly to the cabinet. in that case, wait for the natural fitting of
the gasket or accelerate this process by heating up the part involved with a
normal hairdrier.
71