Lighting; Battery Of The Remote - Atag CU12511RM Anleitung

MAINTENANCE

Lighting

Battery of the remote

Remove the excess water without damaging the filter, remove the
holder and let the filter dry in the oven for at least 40 minutes at a
maximum temperature of 70 °C.
To keep the regenerable carbon filter efficient, this action should be
repeated every 2 months or when indicated by the filter indicator. The
filter must be replaced after no more than 3 years, or if it has been
damaged.
It is important that the grease filters and the regenerable active
carbon filter are thoroughly dry before repositioning.
Replacing the carbon filter:
To replace the carbon filter, consult the manual for the recirculation kit.
This hood is fitted with a light system. This light system has to be
replaced by an authorized technician. Do not attempt to replace it
by yourself.
The lamp in this household appliance is only suitable for
illumination of this appliance. The lamp is not suitable for
household room illumination.
Important!
When the batteries are replaced the pairing connection will remain.
Replace the batteries in time, as the receiving distance will be
shortened if the voltage of the battery is too low.
Don't forget to remove the batteries if you don't use the remote for a
long time.
Don't leave the remote lying upside down on a conductive surface.
The warranty does not cover the batteries.
The battery may drain more quickly in connection with the lit icons.
Battery specifications: Two AAA batteries
EN 13