What You Should Pay Attention To; Igniting And Adjusting - Pelgrim GKB415 Anleitung

safety
48

What you should pay attention to

Ensure that there is adequate ventilation during use
■ Keep natural ventilation openings open.
When using the hob for long periods, extra ventilation is necessary.
■
Open a window for instance or install a mechanical fan.
Use the hob only for preparing dishes
The appliance is not suitable for space heating.
■
Never flambé under an extractor hood
■ The high flames can cause a fire, even if the fan is switched off.
The burner parts are hot during and immediately after use
Do not touch them, and avoid contact with non-heat-resistant materials.
■
■ Never immerse hot burner parts in cold water. The rapid cooling can damage
the enamel.
The distance from the pan to a knob or non-heat-resistant wall should
always be greater than two centimetres
In the case of smaller distances the high temperature may cause the knobs or
■
wall to discolour and/or distort.
Always use the pan supports and suitable cooking utensils
Always place the pan on the pan support. Placing the pan directly on the
■
burner head can result in dangerous situations.
Aluminium trays or foil are not suitable as cooking utensils. They can become
■
burnt into the burners and pan supports.
Installing burner parts and pan supports
■ The hob can only function effectively if the burner parts have been
assembled using the guide ridges.
■ Ensure that the pan supports lie properly against each other and flat on the
spillage well. Only then can the pans be positioned stably.
controls
49

Igniting and adjusting

Each burner can be adjusted continuously between the full and low positions.
GKB410
While keeping the knob of the burner held in,
turn the knob to the left and light the burner
with a match.
GKB415/417/470/472/475/475W/477/477W/478/478W
Press the knob of burner in and turn it
to the left.
The burner ignites.
Flame failure device (GKB416/478/GKB478W)
The flame failure device ensures that the gas supply is closed if the flame goes
out during the cooking process.
Hold the control knob pressed in in the full position for approximately
5 seconds.
The flame failure device will switch on.
0-setting
full setting
low setting
0-setting
full setting
low setting