Herunterladen Inhalt Inhalt Diese Seite drucken

Respekta KM 5500 Bedienungsanleitung Seite 40

Glaskeramik-kochfeld
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Daily contamination of the glass ceramic (fingerprints, stains caused by
1. Disconnect the appliance from the
mains (fuse-box).
2. Use a suitable detergent for glass
ceramic while the glass ceramic is
still warm - but not hot!
3. Clean with a soft cloth/kitchen
paper and water, then dry carefully.
4. Connect the appliance to the mains
again.
Overcooked or melted food and stains caused by heated sugar-containing
Remove
such
immediately with a suitable glass
ceramic scraper. Beware of cooking
zones which are still hot!
1. Disconnect the appliance from the
mains (fuse-box).
2. Hold the scraper in a 30
scrape off the contamination to a
cold area.
3. Clean the contaminated area with a
dish towel/kitchen paper.
4. Proceed as described in steps 2-4 in
the previous section.
1. Disconnect the appliance from the
mains (fuse-box).
2. Take away the contamination.
3. Wipe the sensors with a damp
sponge or cloth.
4. Dry the sensors with kitchen paper.
5. Connect the appliance to the mains.
food, non-sugary spillages).
food on the glass ceramic.
a
contamination
0
-angle and
Contamination of the control panel.
• While the appliance is disconnected
from the mains the residual heat
indicator does not work, so the
cooking zones may be still hot. Be
very careful.
• Scourers,
abrasive detergents can scratch the
glass ceramic. Read the product
information of these detergents, so
you know if they are suitable to
clean glass ceramic.
• Do not leave any residuals of a
detergent on the glass ceramic as it
can turn stained permanently.
• Remove such contaminations as
soon as possible. When they cool
down on the glass ceramic, they are
difficult to remove and may damage
the glass ceramic permanently.
• Be very careful when using the
scraper so that you do not cut
yourself (especially, when you have
removed the safety cover).
The
appliance
automatically turn off. The sensors may
not work properly when they are wet.
Dry the control panel carefully before
you put it into operation again.
40
nylon-scourers
may
beep
and
and

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis