Create FRIDGE RETRO NEVERA Bedienungsanleitung Seite 15

PROBLEM
The temperature within
the appliance is too cold.
Moisture builds up on the
inside or outside walls of
the fridge.
Smell/odour
The doors do not close
properly.
Unusual noises.
The fridge door will not
open.
The compressor runs
continuously.
The external fridge
surface is warm.
Increase the ambient temperature within the fridge by adjusting the thermostat to a
lower setting. The highest setting should only be used as a rapid cool setting and should
only be set 2 hours before storing a large load of food. If this is not done, the temperature
in the fridge compartment could fall below 0°C, as the compressor will run continuously.
A hot and humid environment will contribute to moisture being built-up. This is
normal.
Check that all the food and the drinks in the fridge are within their 'best before'
date and is packaged correctly. If this weren't the case, repackage or throw the
expired food away immediately.
Check for spillage on each shelf, rack and drawer. You may need to remove the
drawers to check that no food or liquids have settled underneath them. Wipe up
any spills immediately to avoid smells and unwanted odours.
Ensure there are no objects obstructing the door.
Make sure all bins and shelves are in their correct position.
Check the door seal is not warped or torn.
Confirm the appliance is level.
Check that the appliance is on a flat, level surface and is stable.
Check the spacing around the appliance and ensure it is not touching other items.
Bubbling and gurgling sound: This noise is the coolant fluid flowing through the
pipes within the system. It's normal.
Water flowing sound: This is the normal sound of water flowing into the drain
during the defrosting process.
If the appliance is operating noisily (compressor noise): This is normal. This noise
indicates that the compressor is operating normally. As the compressor is being ener-
gized, it might run a bit more noisily for a short period of time.
Popping and cracking noises are heard when the inside walls contract/expand,
especially during initial cooldown.
If the door has just been opened, leave it for a few minutes to allow the air pressure to
equalise before trying again.
The temperature is set too cold: select a lower (warmer) setting.
The door is open or something is obstructing proper door closure.
The door gaskets are worn, dirty or damaged.
A large load of food has been added.
The room temperature is higher than normal.
The exterior walls can be warmer than room temp. It's normal while the compressor
is transfering heat from the inside of the fridge.
CAUSE/SOLUTION
E NGLI SH 15