Imetec R1401 Bedienungsanleitung Seite 17

bed and covered with a sheet, blankets or duvet.
• Spread the underblanket (4) out, starting from the bottom, placing it directly
on top of the mattress, with the side with the connector (1) facing towards
the mattress.
• Make sure the underblanket is always fully spread out, with no folds.
• Makethebed,layingthemattresscoverand/orthefirstsheetontopofthe
underblanket. Place the second sheet and the normal blanket or duvet on
top.
CONNECTING THE CONTROL UNIT
• Insert the control unit connector (2) in the underblanket connector (1) to join
the two.
• For the double bed model, repeat this procedure for the second control unit
as well.
• Runthecontrolunitcableonthefloor,nexttothebed.Don'tcrushthecontrol
unit cable between the mattress and the bed frame.
SWITCHING ON AND SELECTING THE RIGHT TEMPERATURE
• The control unit can be set at the following temperature levels:
II: maximum temperature
I: minimum temperature
0: OFF
• Insert the plug of the control unit cable in the mains socket (3).
• To heat the bed, switch the underblanket on by setting the temperature
selector(6)atpositionII(maximumtemperature),thencoverthebedwith
the sheet and blanket or duvet.
• The temperature display (7) switches on, lighting up the selected temperature
level.
NOTE: the time needed for the underblanket to warm up will depend
on the room temperature. The temperature of the underblanket must be
evaluated by lying in the bed rather than just feeling it by hand.
NIGHT-TIME OR CONTINUOUS USE
For night-time or continuous use, set the control unit to
temperature level I only.
EN
16