Basic Operation; System-Setup - Berger & Schroter 32364 Bedienungsanleitung

Camera start
Please insert the batteries before using the camera.
• You can find the battery compartment by opening the camera. In-
sert 4 1.5 V AA batteries. Please pay attention to the correct polarity.
• If the battery level is low, please connect the camera to a power
cable (not included in the scope of delivery).
Insert the memory card
Please prepare the microSD card and insert it into the camera for
data storage. Please format the memory card before taking photos
or videos.
• The camera supports microSD cards of up to 32 GB. It is recom-
mended to use a high speed card of class 6 or higher.
• To prevent malfunction, keep the memory card away from water,
strong vibrations, dust, heat sources and direct sunlight.
• Do not force the memory card. Please follow the markings on the
camera.
• When using the camera for the first time, please wait until the me-
mory card has reached the ambient temperature. Short circuits may
occur in the camera due to the ambient temperature and humidity.
Please ensure that the camera is protected when using it outdoors.
• When the memory card is full, recording stops automatically.
• Gently press the edge of the microSD memory card to remove it.

Basic operation

Switching the camera on and off
Set the mode switch to „Test/On" to switch on the camera. Set the
mode switch to „Off" to switch off the camera.
System setup
Set the mode switch to „Test" to set the system parameters.
1. Press the menu button to enter the setup menu.
2. Press the up/down button to browse the entire menu. Then press
the OK button to open the options interface.
3. Press the Up/Down button to browse all options. Then press OK
to confirm the options.
4. Press the Menu button again to return to the previous menu or
exit the Settings menu.
14