Whirlpool AGB 667/WP Gebrauchsanweisung Und Installation Seite 25

tubes from the detergent and rinse-aid containers and emerge them in a container filled with clean water. Perform a
few wash cycles and drain the machine completely.
Finally, turn off the main switch and close the water supply faucet. The detergent and rinse-aid suction tubes will be
placed back in the containers when the machine is ready to be put back in use, taking care so as not to invert
the tubes (red tube = detergent; transparent tube = rinse-aid).
Do not leave the device on, inactive and unutilized for long periods of time.
PROBLEM
THE LINE LED INDICATOR
DOES NOT TURN ON
THE WASH PROGRAM DOES
NOT START
POOR WASHING RESULTS
RINSE INSUFFICIENT
GLASSES AND SILVERWARE
ARE STAINED
WATER IS PRESENT IN THE
TANK AFTER DRAINING
13
8 PROBLEMS AND ANOMALIES (USER)
POSSIBLE CAUSE
There is no electrical current
The dishwasher has not finished
loading
Sprinkler wash holes are clogged
or encrusted
Detergent or rinse-aid insufficient
or not adequate
Plates / glasses poorly positioned
Low wash temperature
Inadequate cycle setting
Sprinkler nozzles clogged
Calcium encrustations
boiler
Rinse-aid
dispensed correctly.
Water is of a hardness level
above 12°dF or contains many
dissolved salts
Drainage tube is positioned poorly
or is partially blocked
in the
inadequate or not
POSSIBLE REMEDY
Verify the electrical current connection.
Wait for the boiler led indicator light to
turn on.
Disassemble and clean the sprinklers
(10.2 Periodic checks)
Verify detergent type and quantity.
Arrange plates / glasses accordingly.
Verify the temperature shown on the
display, if below 50°C call Assistance.
Increase the duration of the wash
cycle, particularly if dishes are very
dirty or contain partially dried residues.
Verify the cleanliness of the nozzles
and the correct function of any
installed water softeners.
Verify the rinse-aid container and
ensure its adequacy for use with the
water supply. If the problem persists
contact assistance.
Verify that the dishwasher's tube and
drain are not blocked and that the
drain is not in too high of a position;
see the connection diagram.