Installation And Electrical Connection; Installation Of The Drive Into A Shaft - Selve SEL Plus Einstellanleitung

GB

Installation and electrical connection

3. Installation and electrical connection
Important! Risk of injury through an electric shock!
Connection only when de-energised!
Run the drive only after installation.
Warning!

3.1. Installation of the drive into a shaft

1. Attach crown and coupling adapter to the motor and fasten them with the
locking device.
2. Push the drive into the shaft in a positive-locking way. The drive must not be
subject to any impacts. Crown and coupling adapters must not have any play
inside the shaft.
3. Where required, secure the drive axially, e.g. by screwing the shaft to the coupling
adapter. Do not drill holes into the drive area!
4. Attach the shaft with the drive and the shaft cap in the bearings. Do not bend
the motor cable and place it so that it cannot be damaged. To keep water from
getting into the motor, place the motor line in a bend direction downwards, so
that any water can drip off.
5. Attach the curtain to the shaft.
20