Küppersbusch IK 164-4 Z Gebrauchs- Und Montageanleitung Seite 20

D265
5. If after having carried out the previously described
operation there is still some space between the
appliance and the kitchen unit, fit the trimming
provided together with the appliance on the stop
strip (A).
D013
6. Apply covers (B) on joint cover lugs and into hinge
holes.
PR266
7. Separate parts A, B, C, D as shown in the figure.
All manuals and user guides at all-guides.com
A
B B
B
A
C
D
8. Place guide (A) on the inside part of the furniture
door, up and down as shown in the figure and mark
the position of external holes. After having drilled
holes, fix the guide with the screws supplied.
9. Fix cover (C) on guide (A) until it clips into place.
10. Open the appliance door and the furniture door at
90°. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure.
Remove the squares and drill holes with Ø 2 mm
at 8 mm from the outer edge of the door. Place
the small square on the guide again and fix it with
the screws supplied.
20
A
PR166
A
C
PR33/2
8mm
B
PR167
A