In The Event Of Problems - Beurer MG 290 HD-3D Gebrauchsanleitung

The cover for the neck area can be removed using the zip at the side of the control knob for the
height-adjustable neck massage.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
Alternatively, you can hang the device in a wardrobe with a coat hanger. To do so, the coat hanger must be
threaded through the hanging loops on the rear side of the device.
Ensure that you use a stable clothes hanger made from wood that is able to carry the weight of the device.
CAUTION
• If you use the transport lock screws, take care to remove these before starting the device when you
next use it.

9. In the event of problems

Problem
Massage heads
are moving slowly.
Massage heads are
moving in the upper
or lower area only.
Massage heads
not moving.
Cause
The load on the massage
heads is too great.
The massage has been acti-
vated for the limited region.
Appliance not connected to
the power supply.
Device not switched on.
Transport locks were not
removed. Massage mecha-
nism is damaged.
Overheating protection
tripped, device is damaged.
Remedy
Reduce the contact pressure on the head.
Press the full back, upper back, lower back buttons
to change the massage region.
Press the neck button to activate the neck massage.
Connect the plug to the mains supply and switch on
the appliance.
Switch the device on with
Select the massage region.
Contact your authorized dealer or the service ad-
dress.
Contact your authorized dealer or the service ad-
dress.
14
.