In The Event Of Problems; Disposal; Technical Specifications; Warranty/Service - Beurer MG 205 Gebrauchsanweisung

11. In the event of problems

Problem
Massage heads rotating at
reduced speed.
Massage heads only rotate
in the upper or lower
region.
Massage heads not mov-
ing.

12. Disposal

CAUTION
For environmental reasons, do not dispose of the device in the household waste at the end of
its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of
the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equip-
ment). If you have any questions, please contact the local authorities responsible for waste disposal.

13. Technical specifications

Disposal

14. Warranty/service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") provides a
warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not affect the seller's statutory warranty obligations which
ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Beurer guarantees the perfect functionality and completeness of this product.
The worldwide warranty period is 3 years, commencing from the purchase of the new, unused product
from the seller.
The warranty only applies to products purchased by the buyer as a consumer and used exclusively for
personal purposes in the context of domestic use.
German law shall apply.
During the warranty period, should this product prove to be incomplete or defective in functionality in
accordance with the following provisions, Beurer shall carry out a repair or a replacement delivery free of
charge, in accordance with these warranty conditions.
If the buyer wishes to make a warranty claim, they should approach their local retailer in the first
instance: see the attached "International Service" list of service addresses.
The buyer will then receive further information about the processing of the warranty claim, e.g. where they
can send the product and what documentation is required.
Cause
The load on the massage
heads is too great.
The massage has been acti-
vated for the limited region.
Appliance not connected to
the power supply.
Device not switched on.
Overheating protection
tripped, device is damaged.
100-240 V~; 50/60 Hz; 18 W
16
Remedy
Reduce the contact pressure on the head.
Press the full back / upper back / lower
back buttons to change or extend the area.
Connect the plug to the mains supply and
switch on the appliance.
Switch the device on with
Select the massage region.
Contact your authorized dealer or the
service address.
.