BOMANN EBO 7908 IX Bedienungsanleitung, Garantie Seite 26

CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use harsh abrasive cleaners or sharp
metal objects for cleaning the glass surface. The
surfaces can be scratched or destroyed.
• Always consider the application and safety notes
of the detergent.
Removing the oven door
For cleaning and easier access to the oven chamber,
the appliance door can be unhinged.
• Open the appliance door completely.
• Fold the opposite retaining brackets of the hinges
upwards.
• Close the appliance door slightly and lift it out up-
wards.
• When inserting the door, make sure that the notch
of the hinge fits correctly on the protrusion of the
hinge holder.
• Fold the retaining brackets back down, otherwise
the hinges may be damaged when closing the ap-
pliance door.
Cleaning the oven
NOTE:
By cleaning after each use, you avoid that cooking
residues, soiling burn in during the next operation.
Cleaning is then only possible with a lot of effort.
• Depending on the degree of soiling and the sur-
face, clean the appliance and accessories only
with a soft, damp cloth and commercially availa-
ble, food-safe cleaners.
• Soak stiffly soiled areas with a little warm dish-
washing liquid or vinegar cleaner.
• Wipe off grease residues on the seal surrounding
the cooking chamber.
• After cleaning, use a soft absorbent cloth to dry.
Cleaning the glass panes
If necessary, clean the inside of the glass panes.
• Open the oven door.
• Remove the support bar by loosening the screws
on the side of the bar.
• Carefully remove the glass panes forward from
the holder.
• Replace the glass panes and fasten the retaining
strip after you have cleaned and thoroughly dried
the glass.
Changing the bulb
WARNING:
• Make sure that the appliance is turned off from
the power supply (fuse).
• Allow the lamp to cool down before replacing the
bulb. Danger of burns!
NOTE:
Use the correct bulb, heat resistant up to 300°C:
G9 Halogen - 1 x 25 W - 220-240 V~
• Unscrew the lamp cover and
• Change the bulb.
• Screw the lamp cover on tightly
26
clean it with a dry cloth.
and check for proper operation.