Philips hs 890 Bedienungsanleitung Seite 5

• Recharging: 60 minutes.
The shaver can also be charged from a 12 - 24 Volts
(DC) supply using cord connector type HP 1957.
(Available from Philips retailers or Authorised Service
Dealers.) Charging from a 12 - 24 Volts (DC) supply
requires approx. 24 hours.
• Regular cleaning of the shaver means that less
battery energy is consumed, so that more shaving
time becomes available.
• The shaver will not be damaged by leaving it
connected to the mains supply after it is fully
charged.
However, it is not advisable to charge the shaver
permanently as this would shorten the life of the
rechargeable batteries.
4
5 The green pilot light comes on.
If the batteries are almost empty, the
red pilot light will come on as well.
When this light goes out, there is
enough energy in the rechargeable
batteries for one cordless shave
(3 minutes).
6 After 60 minutes the green pilot light
starts to flash. This means that the
shaver is fully charged.
4 Insert the small plug into the
shaver. Ensure that the plug is
pushed fully home. (Note the
indication mark.)
Mains voltages: 100 - 240
Volts. (The shaver adjusts
automatically.)
5