Siemens EQ.500 classic TP5 Serie Gebrauchsanleitung Seite 58

en Cleaning and servicing
¡ If your appliance is not descaled in
good time, the display will show
the following message: "Descaling
overdue. Appliance is locked.
Please press menu for 3 sec.".
¡ If your appliance has been locked,
you can only operate it again once
the descaling process has been
carried out.
¡ If you accidentally interrupt the ser-
vice programme, you must reset it.
→ "Resetting service programmes",
Page 58
Tips
¡ If you use a water filter, this will
prolong the time until you have to
run a service programme.
¡ You can combine "Descale" and
"Clean" using the "calc'nClean"
service programme.
¡ Clean your appliance with a soft,
damp cloth immediately after a
service programme to remove any
descaling solution residues and
prevent corrosion.
Using the service programmes
Notes
¡ If you are using the service pro-
gramme "Cleaning and care",
clean the brewing unit beforehand.
→ "Cleaning the brewing unit",
Page 57
¡ If you are using the service pro-
grammes "Descale" or
"calc'nClean", first clean the brew-
ing unit and prepare the descaling
solution.
Press
1.
Use and
2.
ing and care" and press
Use and
3.
quired programme and press
e.g. "Descale".
a The display will guide you through
the programme.
58
⁠ .
to select "Clean-
⁠ .
to select the re-
Preparing descaling solution
Fill a container with 0.5 l lukewarm
1.
water.
Add a Siemens descaling tablet to
2.
the water and stir until the tablet is
fully dissolved.
Resetting service programmes
Perform the following steps if a ser-
vice programme is interrupted, e.g.
due to a power failure.
Empty the container and put the
1.
end of the suction pipe in the con-
tainer.
Rinse out the water tank.
2.
Fill the water tank with fresh, non-
3.
carbonated water up to the "max"
marking.
Press
4.
a The appliance will rinse itself for
approx. 2 minutes.
Empty and clean the drip tray.
5.
Insert the drip tray and close the
6.
door.
Restart the service programme.
7.
,
⁠ .