Operation - pro user DRC5040 Bedienungsanleitung

5) Route the power cable to the vehicle's cigarette lighter socket 12V/24V power outlet. The
cable must not interfere with the safe operation of the vehicle.
6) Insert the small 12V/24V DC plug of the power cable into the right side of the monitor.
7) Plug the 12V/24V cigarette lighter plug into the vehicle's cigarette lighter socket.
8) To maximize the e ectiveness of the suction mount, it is recommended that the application
be performed under the following conditions:
Surface temperature should be between 21 and 38 degrees Celsius.
•
Application below 10 degrees should be avoided.
•
Application should not occur in direct sunlight.
•
Mounting should be protected from exposure to direct sunlight for a period of 24 hours.
NOTE NOTE: UNDER EXTREME BRIGHT LIGHT CONDITIONS, THE SCREEN IMAGE MAY TAKE A
NOTE NOTE
FEW SECONDS TO STABLIZE. PLEASE WAIT UNTIL THE IMAGE HAS STABLIZED BEFORE
BACKING UP.
System testing System testing
System testing System testing
1) Reattach the vehicle's negative battery cable.
2) Turn the ignition key to the accessory position, do not start the vehicle.
3) Engage the parking brake, and then put the shifter in the reverse position.
4) After testing the unit and you are satisfied with the route you have chosen for the cabling,
you must permanently install it.
5) Route all wires behind interior panels or under carpeting so they are hidden. Use supplied
cable ties to neatly gather any excess wire.
Please always pair the monitor and camera before the 1st operation, please refer to below
"Pairing" step.
There are 6 control buttons available for users to have their controls:
INSTALLATION

OPERATION

1) Power On / O button
2) Parking guidelines display / back button
3) Enter button
4) Down button
5) Up / channels switching button
6) Menu button
7