pro user DRC5040 Bedienungsanleitung Seite 6

8) After determining which wire is the positive and which is the negative, turn o the ignition
key, then remove the battery's negative cable.
9) Splice the red wire using the supplied in‐line wire connectors to the reverse light's positive
(+) wire. Use a set of slip joint pliers to squeeze the TAP and insure good Connection.
10) Next splice the black wire of the camera power cable to the reverse light's negative (‐) wire
or ground.
11) Replace the reverse light bulb, and then re‐install the light socket. Secure all the wires with
cable ties or electrical tape.
12) Re‐attach the negative battery cable to the battery.
Monitor Installation Monitor Installation
Monitor Installation Monitor Installation
When choosing a location to mount the monitor, make sure the monitor is in an area that will not
obstruct your vision while driving.
1) Before mounting the monitor, clean the mounting surface well.
2) Position the suction mount to the smooth surface which suits your
requirement.
3) Press the suction cap against the smooth surface and press the lock down to attach and fix
the mount to the surface.
4) Adjust the mounting arms to suit your view angle to the monitor.
INSTALLATION
6