Montering / Assembly - Abilica XS 2.0 Bedienungsanleitung

MONTERING / ASSEMBLY / ASENNUS/ MONTAGE
Step 1: Assemble Front and Rear Stabilizer
According to the following figure, fix the Front Stabilizer (65) and Rear Stabilizer (66) under the
Main Frame (1) with Flat Mat（70）and Inner Hexagon Flat Round Head Screw （71） by using
Inner Hexagon Wrench.
Step 2: Install Left and Right Pedal
According to the following figure, thread the Left Pedal (50) and the Right Pedal (51) into the
Cranks. Tighten them with the Open Wrench #15. Tighten in counter clockwise direction for left
pedal and clockwise direction for right pedal.
50
1
51
Step 3: Assemble the Handlebar Post
Refer to the following figure, loosen the Pop Pin (4) and slide the Handlebar Post (3) into the
housing on the Main Frame (1). Install and tighten Pop Pin (4) to secure the Handlebar Post.
3
4
7