Abilica XS 2.0 Bedienungsanleitung Seite 8

Step 4: Assemble the Handlebar
Refer to the following figure, attach the Handlebar (2) to the Handlebar Post (3) and tighten it
with the Adjusting Knob (5) and Flat Mat (34).
3
34
Step 5: Assemble the Seat Post
Refer to the following figure, loosen the the Pop Pin (4) and slide the Seat Post (8) into the
housing on the Main Frame. Install and tighten the Pop Pin (4) to secure the seat post.
8
4
Step 6: Assemble the Seat
Refer to the following figure, loosen the Pop Pin (4) and then pull down on the Pop Pin (4) to
insert the Seat Slider (9) into the Seat Post (8). Re-tighten the Pop Pin (4). Attach the Seat (12)
to the Seat Slider (9) with the wrench provided.
12
8
9
4
Step 7: Inspection
Before finishing installation, please inspect all the screws and nuts carefully to make sure all of
them tightened.
8