Before operation, please make sure that the VOLTAGE mentioned on the unit is same as the
voltage of your local area. Unravel the AC power cord, insert one end into the AC socket on the
set, and the other end into a standard AC outlet.
Attention
1. Do not plug or unplug the power cable while you have wet hands.
2. When planning not to use this unit for a long time, disconnect the power cable from the wall
outlet.
3. When disconnecting the power cord from the wall outlet, do not pull on the cord in order to
avoid shock risks caused by damaged cable.
Disconnect the AC cord completely. Open the battery compartment door and insert 6 pieces
LR14 / "C" size batteries into the battery compartment with battery polarity as shown inside the
battery compartment.
1. Set the FUNCTION switch to FM position.
2. Rotate the TUNING control to tune to your desired radio station.
3. Adjust the sound level by rotating the VOLUME control.
4. To turn off the radio, set the FUNCTION switch to OFF position.
For best reception, fully extend the FM Antenna to receive FM stations.
1. Set the FUNCTION switch to the CD position.
2. Insert the CD disc in the CD compartment and close the CD door, the unit will start reading
the disc, the LED display will show the total number of tracks of the entire disc after reading.
3. To start playing the CD, press the
4. To pause CD playback, press the
5. Adjust the VOLUME control to the desired volume level.
6. Press
or
7. Hold
or
8. To stop playing the CD, press the STOP
Repeat Mode
Repeat 1: Press the REP button once, the repeat LED indicator will light and flash continuously.
This single track will be repeated.
Repeat All: Press the REP button twice, the repeat LED indicator will stay lighted. The whole disc
will be played continuously.
To Cancel Repeat Function: Press the REP button until the lighted repeat LED indicator turned
off.
AC OPERATION
BATTERY OPERATION
button to skip to next or previous tracks.
button to search the point of sound quickly
RADIO
CD MODE
button and display LED indicator light on.
button again and display LED indicator is blinking.
button.
2
SCD1400 / English Instruction Manual