Eu Declaration Of Conformity - Gardena CST 3018 Betriebsanleitung

The undersigned Husqvarna AB, S-561 82, Huskvarna, Sweden, hereby certifies that, when leaving our factory,
the units indicated below are in accordance with the harmonised EU guidelines, EU standards of safety and
product specific standards. This declaration becomes void if the units are modified without our approval.
Description of Unit......................Chainsaw
Type(s) ......................................CST3018, CST3518 - CS = Chainsaw
Year of CE Marking.................... 2009
EU Directives:
2006/42/EC, 2004/108/EC, 2000/14/EC, 2011/65/EU
Harmonised EN:
EN60745-1, EN60745-2-13, EN50366, EN55014-1, EN61000-3-2, EN61000-3-11
Notified Body that carried out the EC type-examination...............
Certificate no. ............................................................................... M3 69240048
Ulm 15/02/2013
Peter Lameli
Global R & D Director - Hand Held
Keeper of technical documentation
Type
Art. No.
Dry Weight (kg)
Power (kW)
Oil tank volume (cm
Chain pitch (inches)
Chain gauge (mm)
Maximum length of guide bar (mm)
Measured Sound Power L
Guaranteed Sound Power L
Sound pressure L
Uncertainty K
Hand / arm vibration a
Uncertainty K
Mains-Impedance Z
Cutting Speed (m/s)
1) Working area related emission characteristic level L
Vibrations value a according to EN60745-2-13 given in the table.
h
The declared vibration total value has been measured in accordance with a standard test method and may
be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning:
The vibration emission during actual use of the power tool can differ from the declared total value depending
on the ways in which the tool is used
Operators should identify safety measures to protect themselves that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle in addition to the trigger time).
2) The Noise Level L
WA
Conformity Assessment Procedure............ Annex V
EN 61000-3-11 Compliance statement
Depending on the characteristics of the local electricity supply network, use of this product may result in short
voltage drops at the instant of switching on. This may influence other electrical equipment e.g a momentary
dimming of a lamp. If the Mains impedance Zmax of your electricity supply is less than the value shown in the
table (applicable to your model) then these effects will not occur. The value of the network impedance may be
determined by contacting your electricity supply authority.

EU Declaration of Conformity

3 )
1) (dB(A))
pA
(dB(A))
pA
1)
h
(m/s 2 )
ah
(
max
values according to 2000/14/EC are given in the table.
MEEI Kft., 1007
Váci út 48/a-b
1132 Budapest
Hungary
CST3018
2) (dB(A))
WA
2) (dB(A))
WA
(m/s 2 )
Ω)
according to EN60745-2-13 given in the table.
pA
ENGLISH - 10
CST3518
8864 8860
5.4 5.5
1.8 1.8
180 180
3/8 3/8
1.3 1.3
300 350
106 106
108 108
95 95
2.5 2.5
3.4 3.4
1.5 1.5
0.382 0.382
10 10