Herunterladen Inhalt Inhalt Diese Seite drucken

Disposing Of The Packaging; Disposing Of Your Old Cooler/Freezer; Placing And Installation; Changing The Illumination Lamp - Beko BSS 123000 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für BSS 123000:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 19
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before
it is repaired! There is the risk of
electric shock!

Disposing of the packaging

The
packing
dangerous for children. Keep the
packing materials out of the reach
of children or dispose of them by
classifying them in accordance with the
waste instructions stated by your local
authorities. Do not throw away with
regular house waste, throw away on
packaging pick up spots designated by
the local authorities.
The packing of your cooler/freezer is
produced from recyclable materials.
Disposing of your old cooler/
freezer
Dispose of your old cooler/freezer
without giving any harm to the
environment.
• You may consult your authorized
dealer or waste collection center of
your municipality about the disposal of
your cooler/freezer.
Before disposing of your cooler/
freezer, cut out the electric plug and, if
there are any locks on the door, make
them inoperable in order to protect
children against any danger.
materials
may

Placing and Installation

A
If the entrance door of the room
where
the
installed is not wide enough for the
cooler/freezer to pass through, then
call the authorized service to have them
remove the doors of your cooler/freezer
and pass it sideways through the door.
be
1. Install your cooler/freezer to a place
that allows ease of use.
2. Keep your cooler/freezer away from
heat sources, humid places and direct
sunlight.
3. There must be appropriate air
ventilation around your cooler/
freezer in order to achieve an efficient
operation. If the cooler/freezer is to be
placed in a recess in the wall, there
must be at least 5 cm distance with
the ceiling and at least 5 cm with the
wall. Do not place your product on the
materials such as rug or carpet.
4. Place your cooler/freezer on an even
floor surface to prevent jolts.
Changing the illumination
lamp
To change the Bulb/LED used for
illumination of your refrigerator, call your
Authorized Service.
9
EN
cooler/freezer
will
be

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis