Teka RBF 78720 SS Bedienungsanleitung Seite 81

ERROR
TYPE
[Sr] – Set
value blink
Refrigerator
on cooler
compartment too cold
set value
screen
"Low voltage"
"[--]"
Warning
If you are experiencing a problem with your refrigerator, please check the following before
contacting the after-sales service.
Your refrigerator does not operate
Check if:
• Your fridge is plugged in and switched on
• The fuse has blown
• Is the temperature adjustment right?
• The socket is faulty. To check this, plug another working appliance into the same socket.
Your refrigerator is performing poorly
Check if:
• Is the temperature adjustment right?
• Is the door of your fridge opened frequently and left open for a long while?
• The appliance is overloaded
• The doors are closed properly
• Did you put a dish or food on your fridge so that it contacts the rear wall of your fridge
so as to prevent the air circulation?
• Is your fridge filled excessively?
• There is an adequate distance between the appliance and surrounding walls
• Is the ambient temperature within the range of values specified in the operating manual?
Your refrigerator is operating noisily
The following noises can be heard during normal operation of the appliance.
Cracking (ice cracking) noise occurs:
• During automatic defrosting.
• When the appliance is cooled or warmed (due to expansion of appliance material).
Clicking noise occurs: When the thermostat switches the compressor on/off.
Motor noise: Indicates the compressor is operating normally. The compressor may cause
more noise for a short time when it is first activated.
Bubbling noise and splashing occurs: Due to the flow of the refrigerant in the tubes
of the system.
Water flowing noise occurs: Due to water flowing to the evaporation container. This
noise is normal during defrosting.
MEANING
The food will start to
freeze because the
temperature is too
cold.
This is seen when
the power supply
becomes lower than
170 V.
WHY
1. Check if the Super Cooling mode
2. Decrease the refrigerator
This not a failure. This prevents any
damage to the compressor. This
warning will clear after the voltage
reaches the required level.
EN -80-
WHAT TO DO
is switched on.
temperature values.