Qwic PMN360 Bedienungsanleitung Seite 44

Selection field
The following information can be seen in the 'selection
field' of the display. You can switch through the
different types of information by pressing the 'LOGO'
button. The following information can be seen if the
selected language is set to English.
RPM: Revolutions Per Minute, show the current
cadence (revolutions of the pedals). When the RPM
is shown you can also see an up or down arrow. This
shows in which direction you could shift gears for a
better system efficiency.
Tip: Both you, as user, and the motor perform most
efficiently between 55 and 80 rpm. On those pedal
speeds the least amount of enery will be lost, and the
motorpower and range are optimal.
CLOCK: Shows the clock, this can be set to 12 hour or
24 hour format.
DISTANCE: The total distance travelled since the last
RESET.
RIDETIME: The total time travelled since the last
RESET.
44
AVERAGE: The average speed, this is calculated as
the total distance travelled divided by the total time
travelled (since the last RESET).
MAXIMUM: Shows the maximum speed since the last
RESET.
ODOMETER: The total distance travelled.
BOOST: The walk-assist mode, which is in use as long
as the 'PLUS' or 'MINUS' buttons are pressed. The walk-
assist knows a speed of around 5 km/h. This function
may only be used when you are pushing the bicycle.
RESET: If you press the 'MINUS' button at the reset
selection, all the data of DISTANCE, RIDETIME, AVERAGE
and MAXIMUM will be reset to 0. Resetting is only
possible when the bicycle is in standstill.
Display & Controls: Midmotor models