Failure Codes - Qwic PMN360 Bedienungsanleitung

Failure codes

It is possible that failures occur. If this happens, go to
the dealer as soon as possible so repairs can be carried
out quickly. The following codes can be displayed on
the display:
Code 01: Problem with 3-phase control from the controller of motor
Code 02: Problem with throttle connection (not in use)
Code 03: Motorcable 3-phase wiring loose or defective
Code 04: Motorcable Hall Sensor signal malfunction (malfunction in motor or motorcable)
Code 05: Malfunction in brake sensor(signal)
Code 06: Battery voltage too low
Code 07: Motorcable is connected incorrectly
Code 08: Malfunction in display signal
Code 09: Malfunction in pedalsensor(signal)
Code 10: Malfunction in display signal
Display & Controls: Rearmotor models 41