Operation - Husqvarna K 1270 SmartGuard Bedienungsanweisung

3. Remove the 2 screws from the adjustment handle for
the blade guard.
4. Remove the adjustment handle for the blade guard
5. Remove the stop sleeve.
Introduction
WARNING:
safety chapter before you use the product.
Kickback
WARNING:
can be very violent. The power cutter can be
thrown up and back towards the user in a
rotating motion causing serious or even fatal
injury. It is vital to understand what causes
16

Operation

Read and understand the
Kickbacks are sudden and
6. Move the bearing housing and install the stop
sleeve.
7. Install the stop sleeve.
8. Install the drive belt on the opposite side.
9. Install the cutting head and the drive belt cover, refer
To replace the drive belt on page 29 .
to
10. Install the spray nozzle and the cutting blade in the
opposite sequence to how they were removed.
kickback and how to avoid it before using
the product.
Kickback is the sudden upward motion that can occur if
the blade is pinched or stalled in the kickback zone.
Most kickbacks are small and pose little danger.
However a kickback can also be very violent and throw
the power cutter up and back towards the user in a
rotating motion causing serious or even fatal injury.
Reactive force
A reactive force is always present when cutting. The
force pulls the product in the opposite direction to the
blade rotation. Most of the time this force is insignificant.
1631 - 001 - 04.05.2021