Product Features; Preparations For Use - Atlas KFS 227 Bedienungsanleitung

Note：Given the limit values of the ambient temperature range for the climate classes for which the refrigerating appliance
is designed and the fact that the internal temperatures could be affected by such factors as location of the refrigerating
appliance, ambient temperature and the frequency of door opening, the setting of any temperature control device might
have to be varied to allow for these factors, if appropriate.
If the power cable is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Note:When operating in an environment other than the specified climate type (i.e., beyond the rated ambient
temperature range), the appliance may not be able to maintain the desirable compartment temperatures.
Locks
If your Refrigerator is fitted with a lock, keep the key out of reach and not in the vicinity of the appliance to prevent children
being entrapped. When disposing of an old Refrigerator, break off any old locks or latches as a safeguard.
Freon-free
The freon-free refrigerant (R600a) and the foaming insulation material (cyclopentane) that is environmentally friendly are
used for the refrigerator, causing no damage to the ozone layer and having a very small impact on the global warming.
R600a is flammable, and sealed in a refrigeration system, without leakage during normal use. But, in case of refrigerant
leakage due to the refrigerant circuit being damaged, be sure to keep the appliance away from open flames and open the
windows for ventilation as quickly as possible.
II. Product Features
•
Electronic temperature control
•
Reversible door
BCD-227
Due to technological innovation, the descriptions of the product in this manual may not be completely consistent with your
refrigerator. Details are in accordance with the material item.
III.

Preparations for use

Installation location
1. Ventilation condition
The position you select for the refrigerator installation should be well-ventilated and has less hot air. Do not locate the
refrigerator near a heat source such as cooker, boiler, and avoid it from direct sunlight, thus guaranteeing the
refrigeration effect while saving energy consumption. Do not locate the refrigerator in the damp place, so as to prevent
the refrigerator from rusting and leaking electricity. The result of the total space of the room in which the refrigerator is
installed being divided by the refrigerant charge amount of the refrigerator shall not be less than 8 g/ M
Note: The amount of refrigerant charged for the refrigerator can be found on the nameplate.
2. Heat dissipation space
When working, the refrigerator gives off heat to surroundings. Therefore, at least 30mm of free space should be spared
at the top side, more than 100mm on both sides, and above 50mm at the back side of the refrigerator.
Dimensions in mm
W D
540 550
T
H A B
1593 910 1055
from +16°C to +43°C
No Description
1 Thermostat
2 Refrigerator Glass Shelves
3 Crisper Cover
4 Crisper
5 Frozen drawers
6 Adjusting feet
7 Bottle frames
C(°) E
135 50
3
.
F
100