Installing The Battery Pack; Removing The Battery Pack - Toro PowerPlex 88526 Bedienungsanleitung

Figure 4
1. Charger venting areas
2. Left indicator light
6. To remove the battery pack, slide the battery
backward out of the charger.
7. Refer to the following table to interpret the LED
indicators on the battery charger.
Left Light Right Light
Off Red
Red Red
Green Red
Orange Red
Red Blinking Red
g194423
3. Right indicator light
Indicates:
Charger is on; no battery
pack inserted
Battery pack is charging
Battery pack is charged
Battery pack is too warm
Replace the battery pack

Installing the Battery Pack

Important:
Operate the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
1. Make sure that the vents on the battery are clear
of any dust and debris.
2. Line up the cavity in the battery pack with the
tongue on the tool.
3. Grasp the trigger handle.
4. Slide the battery pack into the tool until the
battery locks into the latch
(Trimmer shown)
1. Battery latch

Removing the Battery Pack

Press the battery latch on the tool to release the
battery pack and slide the battery pack out of the tool
(Figure 6).
(Trimmer shown)
1. Battery latch
8
6).
(Figure 5).
Figure 5
Figure 6
g189881
g192774