Powerfix Profi 95908 Bedienungs- Und Sicherheitshinweise Seite 6

Operation
Q
Filling with staples / nails
Q
CAUTION! Use only the staples and nails
described in these operating instructions (see
"Staples / nails"). Failure to observe this advice
may result in damage to the device.
Follow these steps:
1. Press in the staple pusher
pull it downwards. Then pull the staple pusher
completely out of the magazine
2. Push the staples or the T-nails into the
magazine 4 .
CAUTION! Ensure that the staples or T-nails
are correctly inserted (see Figs. B, C, D).
3. Push the staple pusher
magazine . Press in the staple pusher
4
slightly and then pull it slightly upwards to fix it
in place.
Setting the impact force
Q
CAUTION! Never screw the adjusing screw
completely out of the stapler gun. This could
result in damage to the device.
j Screw out the adjusing screw
the impact force.
j Screw in the adjusing screw
the impact force.
Stapling
Q
CAUTION! Never support yourself by placing
your hands near or in front of the stapler gun
or the workpiece surface. A slip can result in
injury.
Follow these steps:
1. Press the staple eject opening
where you wish to staple.
2. Adjust the impact force to suit the materials,
staples or nails.
3. Press the operating lever
6 GB/IE
95908_GB_IE_FI_DK_Content.indd 6
slightly and then
2
2
(see Fig. A).
4
back into the
2
2
7
7 to reduce
7 to increase
6 on the spot
down firmly.
1
Examples of use:
The stapler gun is suitable for the following purposes:
- Attaching coverings to the seating surface of
chairs.
- Attaching a skirting at the joint between wall
and floor coverings.
- Stretching and stapling canvasses to frames.
- Attaching protective films to insulation materials
when installing thermal insulation.
- Attaching decorative materials.
Removing staples
Q
To avoid the risk of injury!
Ensure that the operating handle
j
pressed
Push the hook under the staple or nail head
j 3
(see Fig. F).
j Pull the rear part of the stapler gun upwards to
draw out the staple or nail from the workpiece.
Removing jammed staples
Q
from the stapler gun
Staples or nails may become jammed in the stapler
gun during operation. Remove jammed staples as
follows:
1. Press in the staple pusher
pull it downwards. Then pull the staple pusher
completely out of the magazine
2. Turn the stapler gun over so that the magazine
4 is pointing upwards.
3. Press the magazine
4
backwards and pull the magazine
(see Fig. E).
4. Now remove the jammed staples from the
magazine .
4
5. Press the magazine 4
backwards and press it downwards until it
engages to fix the magazine
Note: Do not use the stapler gun if it shows more
serious defects (damage to body etc.). If necessary
have your stapler repaired by a qualified specialist.
Take note that the manufacturer's original spare
will not be
1
slightly and then
2
2
.
4
at the side wings
5
upwards
4
at the side wings 5
back in place.
4
2/7/2014 2:21:44 PM