Fellowes Powershred 12C Bedienungsanleitung Seite 2

A.
B.
C.
CAPABILITIES
Will shred: Paper, small paper clips, plastic credit cards, staples, and unopened
junk mail
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper,
CD/DVDs, cardboard, large paper clips, laminates, file folders, X-rays or plastic other
than noted above
Paper shred size:
Cross-Cut .............................................................................................4mm x 40mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
the instruction manual. Read the entire instruction manual before
operating shredders.
from paper entry. Always set to off or unplug when not in use.
from shredder openings. If object enters top opening, switch to
Reverse (
on or near shredder. DO NOT USE "CANNED AIR" OR "AIR
DUSTERS" ON SHREDDER. Vapors from propellants and petroleum
based lubricants may combust causing serious injury.
head.
Do not place near or over heat source or water.
2
D.
E.
F.
G.
) to back out object.
KEY
A. Paper/card entry G. Control switch and LEDs
B. Pull-out bin
C. Window
D. Disconnect power switch
1. OFF
2. ON
E. See safety instructions
F. Safety lock
To set lock slide
button down
Maximum:
Sheets per pass ...................................................................................................12*
Cards per pass .......................................................................................................1*
Paper width ...................................................................................................224mm
* 70g A4 paper at 220-240v, 50/60Hz, 1.5Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates:
500 sheets; 25 cards.
to operate shredder. In case of emergency, move switch to OFF ( ) position.
This action will stop shredder immediately.
the voltage and amperage designated on the label. The grounded outlet or
converters, transformers, or extension cords should not be used with this
product.
ENGLISH
Model 12C/FS-12C
1. Reverse
2. Off
3. Auto-On
4. Remove paper (red)
5. ON/OFF (white)
6. Overheat (red)