Before Starting The Equipment - EINHELL 44.305.60 Originalbetriebsanleitung

Anleitung_RT_AG_125_SPK1:_
GB
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
5.1 Fitting the additional handle (Fig. 2)
The angle grinder must not be used without the
additional handle (4).
The additional handle can be secured in any of
three positions (A, B, C).
Tool side
Left (position A / as Right-handed users
shown)
Right (position B) Left-handed users
Top (position C) Using cutting wheels
5.2 Setting the guard (Fig. 3)
Switch off the tool. Pull the power plug.
Adjust the guard (5) to protect your hands so that
the material being ground is directed away from
your body.
The position of the guard (5) can be adjusted to
suit the working conditions; turn the cover (5) into
the required position. The locking lug (a) on the
guard (5) must engage in the appropriate
position (b).
Ensure that the guard (5) correctly covers the
gear wheel casing.
Ensure that the guard (5) is securely engaged in
the correct position (b).
Take care that the safety device is secure.
Never use the angle grinder without the
guard.
12
23.11.2009 13:53 Uhr
5.3 TEST RUN FOR NEW GRINDING WHEELS
Allow the right-angle grinder to run in idle for at least
1 minute with the grinding or cutting wheel fitted in
place. Vibrating wheels are to be replaced
immediately.
6. Operation
6.1 Switch (Fig. 4)
The angle grinder comes with a safety switch which is
designed to prevent accidents. To switch on, push
the switch (a) down while at the same time pushing
the ON/OFF switch (3) forwards. To switch off the
angle grinder, depress the ON/OFF switch (3) at the
back. The ON/OFF switch (3) will jump back into its
starting position.
Wait until the machine has reached its top
speed. You can then position the angle grinder
on the workpiece and machine it.
6.2 Changing the grinding wheels (Fig. 5 / 6)
Use the face spanner (6) supplied to change the
grinding wheels. The face spanner (6) is stored in the
Suitable for
additional handle (4). Pull the face spanner (6) out of
the additional handle (4) when you need it.
Important! For safety reasons, the angle grinder
must not be operated with the face spanner (6)
inserted in it.
Pull out the power plug.
Simple wheel change by spindle lock:
Press the spindle lock and allow the grinding
wheel to latch in place.
Open the flange nut with the face spanner.
(Fig. 6)
Change the grinding or cutting wheel and tighten
the flange nut with the face spanner.
Important!
Only ever press the spindle lock when the motor
and grinding spindle are at a standstill!
You must keep the spindle lock pressed while
you change the wheel!
For grinding or cutting wheels up to approx. 3 mm
thick, screw on the flange nut with the flat side facing
the grinding or cutting wheel.
Seite 12