Intended Use; Additional Safety Rules - Panasonic EY3640 Bedienungsanleitung

I

. INTENDED USE

Thank you for purchasing the Panasonic
Sealing Gun. This Sealing Gun is for
pushing the sealing compounds. Sausage
type and cartridge type are applicable for
this model. The speed can be adjusted
according to work.
II
. ADDITIONAL
SAFETY RULES
1) Be aware that this tool is always in an
operating condition, since it does not
have to be plugged into an electrical
outlet.
) Be careful not to get your ties or wide
cuffs rolled into the rack.
3) Stop using the tool if you notice
something abnormal.
4) During charging, the charger may
become slightly warm. This is normal.
Do NOT charge the battery for a long
period.
5) The appliance is not intended for use
by young children or infirm persons
without supervision.
6) Young children should be supervised
to ensure that they do not play with the
appliance.
WARNING:
• Do not use other than the Panasonic
battery packs that are designed for use
with this rechargeable tool.
• Do not dispose of the battery pack in a
fire, or expose it to excessive heat.
• Do not drive the likes of nails into the
battery pack, subject it to shocks,
dismantle it, or attempt to modify it.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack
in the same container as nails or similar
metal objects.
• Do not charge the battery pack in a
high-temperature location, such as next
to a fire or in direct sunlight. Otherwise,
the battery may overheat, catch fire, or
explode.
• Never use other than the dedicated
charger to charge the battery pack.
Otherwise, the battery may leak,
overheat, or explode.
• After removing the battery pack from
the tool or the charger, always reattach
the pack cover. Otherwise, the battery
contacts could be shorted, leading to a
risk of fire.
Preparing the sealing gun
For preparation of sealing compound,
such as cutting the opening to the desired
diameter, follow the instructions of the
cartridge / sausage pack.
III
. ASSEMBLY
Attaching or Removing
Battery Pack
CAUTION:
Before inserting battery pack, check that
the power switch in the tool actuates
properly and returns to the "OFF" position
when released.
1. To connect the battery pack (Fig. 1)
Line up the alignment marks and attach
the battery pack.
• Slide the battery pack until it locks into
position.
. To remove the battery pack (Fig. )
Push on the button from the front to
release the battery pack.
Inserting the sealing
compound into the gun
For use with cartridges
1) Cut off the tip of nozzle at a point
suitable for the job. (Fig. 3)
) Pull the rack all the way to rear. (Fig. 4)
3) Unscrew the tube holder from the
housing, and remove the sausage
pack adapter from the rack. (Fig. 5)
4) Install the tube holder on the housing,
remove the front cap from the tube
holder, and insert the cartridge. (Fig. 6)
- 7 -