Safety Regulations; Layout And Items Supplied - EINHELL TE-BD 550 E Originalbetriebsanleitung

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Machine base
2. Pillar
3. Guide groove
4. Drill table
5. Drill table clamp shaft
6. Machine head
7. V-belt cover
8. Motor
9. Rotary feed handle
10. Chuck
11. Spindle
12. Mounting holes
13. Folding chip guard
14. screw depth adjustment collar
15. Speed control lever
16. Fastening screws for chip guard
17. Digital display
18. ON switch
19. OFF switch
20. Adjustment screw for chip guard
21. Height adjustment screw for chip guard
22. Stop screw for chip guard
23. Fastening rail for chip guard
24. Chuck size
Anl_TE_BD_550_E_SPK9.indb 20 Anl_TE_BD_550_E_SPK9.indb 20
GB
25. Scale ring
26. Socket head screw
27. Hex key 6 mm
28. Hex key 4 mm
29. Hex key 3 mm
30. Clamping screw for drill table support
31. Fastening screws
32. Holder for chip guard
33. Locking screw for V-belt cover
34. Drive pulley
35. V-belt
36. Variable pulley
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Original operating instructions
•
Safety instructions
•
Pillar drill
•
Chuck
•
Folding chip guard
- 20 -
16.06.2020 12:46:37 16.06.2020 12:46:37