Device And Sensor Settings - Dräger X-am 2800 Gebrauchsanweisung

Feature
Alarm A2
Expired bump test interval
Expired calibration interval
1) The set capture range can be read out on the gas detector and activated or deactivated. The cap-
ture range is activated in measuring mode ex works. The capture range is always deactivated in
calibration mode.
2) An LEL factor can be adapted to national regulations using the Dräger CC-Vision PC software.
3) Notation in the gas detector: ch4
6.2

Device and sensor settings

Name:
Device settings:
Password(s)
Acoustic operation signal
Switch-off mode
Short-term exposure limit (STEL)
Shift length (TWA)
Sensor settings:
A1 alarm:
Latching
Acknowledgeable
A2 alarm:
Acknowledgeable
Alarm threshold A1 increasing
(in measurement module)
Alarm threshold A2 increasing
(in measurement module)
Alarm threshold A1 decreasing
(in measurement module, only O
sor)
®
X-am 2800
1)2)
3)
4)
sen-
2
Setting
Not acknowledgeable; latching, main
alarm, increasing measured value (for
O sensor, decreasing measured value
2
as well)
Channel warning
Channel warning
Area / setting
Numerical range (4-digit)
Yes / No
"Switch off allowed" or
"Switch off forbidden" or
"Switch off forbidden in A2"
0 - 60 (in minutes; setting for exposure
alarm)
60 - 1440 (in minutes; setting for expo-
sure alarm)
On / Off
On / Off
On / Off
0 to A2
A1 to full scale deflection
A2 decreasing to A1 increasing
|
Device settings en
61