Klarstein 10034710 Bedienungsanleitung Seite 36

EN
36
Trying to light wrong
burner
Burner not engaged with
control valve
Obstruction in burner
Burner will not light
using ignitor
No gas flow
(Gas issues)
Vapor lock at coupling nut
to LPtank
Coupling nut ad LP tank
valve not fully connected.
See instructions on control
panel and section in the
Use and Care.
Make sure valve are
positioned inside of burner
tubes.
Ensure burner tubes are
not obstructed with spider
webs or other matted, see
cleaning section of use
and care
Make sure LP tank is not
empty. If LP tank is not
empty, refer to "sudden
drop in gas flow.
Turn off knobs and
disconnect coupling nut
from LP tank. Reconnect
and retry.
Turn the coupling nut
approximately one-half to
three-quarters