Preparing The Icemaker For Long Storage - Hoshizaki FM-1200ALKE-R452-SB Bedienungsanleitung

ENGLISH
Note: A plumbing permit and services of a licensed
plumber may be required in some areas.
* The connections to the mains water supply must
be made in accordance with the countries' current
requirements of the Water Supply or Water Fittings
Regulations.
* Icemaking water must be potable water. Where
scaling can be caused by water quality, installation
of an external filter or softener is recommended.
Contact your local water treatment professional or
Hoshizaki service agent.
II. OPERATING INSTRUCTIONS
WARNING
1. This icemaker is designed to produce and
store edible ice. To keep the icemaker
hygienic:
* Wash your hands before removing ice. Use
the plastic scoop provided (accessory).
* The storage bin is for ice use only. Do not
store anything else in the bin.
* Clean the storage bin before use (see "III.
1. CLEANING").
* Keep the scoop clean. Clean it by using a
neutral cleaner and rinse thoroughly.
* Close the door after removing ice to prevent
entrance of dirt, dust or insects into the
storage bin.
2. All parts are factory-adjusted. Improper
adjustments may result in failure.
3. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the compressor.
1. START UP
The installer will normally commission the icemaker
to start the automatic icemaking process. To ensure
continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is connected to the power supply.
To start the icemaking process, check the position of
the operation switch on the operation panel:
"OFF" position - Move it to the "ON" position.
"ON" position - Press the ice button.
Operation Panel
Ice Button Display
Maintenance Button
(service use only)
2. SHUT DOWN
Press the stop button on the operation panel. The
"STOP" and "DRAIN" modes light up on the display.
Then, only the "DRAIN" mode goes off.
3. PREPARING THE ICEMAKER FOR LONG
STORAGE
1) Follow the instructions in "2. SHUT DOWN".
2) Close the water supply line shut-off valve.
3) Open the drain valve.
4) Press the ice button on the operation panel to drain
the water circuit.
5) When no more water comes out of the drain valve,
press the stop button.
6) Move the operation switch to the "OFF" position,
and disconnect the power supply.
7) Close the drain valve.
8) Remove all ice from the storage bin, and clean the
bin.
4
Stop Button
Operation Switch
Fig. 1