Prolonged Inactivity - Nordcap FKM 2 PLUS Bedienungsanweisung

3.4 Replacement of Power Cord
If the power cord is damaged, this must be replaced by the manufacturer, by its technical services or by qualified person to avoid
danger.
4 Recommendations for the User
This cooling unit has been designed for keg boxes and stock cabinets.
This equipment has been created to work at a 4 climatic class (30ºC room temperature, 55% Hr).
Children should be supervised to ensure that they do not play with the device.
To ensure that they function well, the following points must be followed:
Do not block the frontal air vent as this will seriously affect the efficiency of the compressor.

Do not use pointed objects to remove ice - that could damage the evaporator and be dangerous to health and

environment.
If you do not follow the above advises, there will be an increase usage electrical energy.

4.1 Start-up
Make sure that the plug is correctly inserted in the socket or that the appliance's circuit breaker is on.
After this, switch on the appliance. To do so, all you have to do is:
1 - Press button "A", placing it in the "ON" position. The green light will come on and indicate connection. At the same time, the
display will flash for some seconds until it indicates the inner temperature.
2 - Temperature is controlled automatically through the electronic thermostat "B".
4.2 Defrost
The appliance defrosts automatically. Switch "B" goes on according to the defrosting stage. After defrosting the switch goes off
automatically - it is also possible to do manual defrosting (besides the ones already programmed).
It is advisable not to open the doors after defrosting so that the normal temperature is obtained more rapidly. Defrosting and
condensation water goes into a tray placed under the evaporator and is directed to a collecting tray, where it is evaporated.
4.3 Cleaning
To ensure perfect hygiene and conservation, please clean as follows:
Cleaning the surfaces carefully with a damp cloth.

4.4 Maintenance
To ensure that the cooling system lasts for a long time and functions correctly, regular maintenance of
the condenser should be carried out. This should be done in the following way:
Switch off the appliance and unplug it.

Open the compressor compartment; the condenser will be easily accessible.

Pass the vacuum cleaner across the condenser in the slat's direction.

Be careful not to stretch the cables, do not stretch them. Remember to close the compartment.


4.5 Prolonged Inactivity

When long periods of inactivity are foreseen, the following procedure is recommended:
Unplug the appliance.

Carry out maintenance operations.

Instruction Manual
Power cord:
- Type
- Nominal Section
- Producer Code
(normal)
(Great Britain)
8
N.º
HO5VVF
3 x 1 mm2
43001004
43001001
MNS00007_02
(17)