Operating Instructions - Audiovox VME 9312 TS Bedienungsanleitung

OPERATING INSTRUCTIONS

Power On / Off
Press the /SRC button (6) on the unit (or the
buttons on the front of the unit light up and the current mode status appears in the LCD (7). You can also turn on the
unit by pressing the OPEN button (1) and opening the TFT screen.
Press and hold the button to power off the unit.The monitor is drawn back into the main compartment.
Audible Beep Confirmation
An audible beep tone confirms each function selection. The Beep tone can be disabled through the Setup menu.
Mute
Press the MUTE button on the front panel (8) or remote control (3) to mute the volume from the unit. Press the MUTE
button again to restore the volume. "MUTE" is displayed on the LCD. Adjusting the volume or using any of the audio
setup features cancels the mute function. External peripheral devices can be connected to this unit via RCA output or
MediaLink. Select "AUX" mode to access and control connected auxiliary devices.
Playing Source Selection
Press the SRC button (6) on the front panel or the SRC button (8) on the remote to change between available playing
sources in the following order: AM/FM/RDS, DISC, AUX, DVB-T and CAMERA (Navigation and iPod can be selected if
connected). The playing mode is displayed on the TFT and LCD screens.
Volume Adjustment
To increase or decrease the volume level, turn the rotary encoder (5) on the front panel or press the VOL+/ VOL but-
tons (15, 16) on the remote control. When the volume level reaches "0" or "40", a beep sounds, indicating that the
adjustment limit has been reached. The volume ranges from "0" to "40". The LCD or TFT screen displays the volume
level for 3 seconds.
Audio Control Menu
The Audio Control feature allows you to easily adjust your audio system to meet the acoustical characteristics of your
vehicle, which vary depending on the type of vehicle and its measurements. Proper setting of the Fader and Balance
boosts the effects of the cabin equalizer. Press the AUDIO button (5) on the front panel once to display the audio menu.
To adjust an audio feature:
1. Turn the rotary encoder (5) on the front panel, press the
(>>|) / (|<<) buttons (14, 22) on the remote control, or use the joystick to highlight the audio feature
to be adjusted.
2. Press the joystick button (13) to select the highlighted option.
3. Rotate the AUDIO button (5), press the |<<, >>|, >>, or << buttons (17, 19, 14, 22) on the remote control, or
use the joystick to adjust the selected feature to the desired setting.
/ POWER button (4) on the remote control) to turn the unit on. The
61