Using The Tft Monitor - Audiovox VME 9312 TS Bedienungsanleitung

USING THE TFT MONITOR

Open/Close TFT Monitor
Open TFT Monitor
Press the OPEN button (1) on the front panel or press the ( ) button (25) on the remote control to activate the
mechanism that moves the display panel into the viewing position.
Close TFT Monitor
Press the OPEN button (1) on the front panel or press the ( ) button (25) on the remote control to load the display
panel back into the compartment.
TFT Monitor Auto Open
If "TFT Auto Open" is "on" when the unit is turned on, the monitor automatically moves to the viewing position.
If "TFT Auto Open" is "off" when the unit is turned on, press the OPEN button (1) or ( ) button (25) on the remote
control to move the monitor into the viewing position.
If "TFT Auto Open" is set to "Manual", the TFT will not close when the key is turned off.
Monitor Tilt Angle Adjustment
A known characteristic of LCD panels is the quality of the display in relationship to the viewing angle. The monitor
angle can be adjusted for optimum viewing using one of the following methods:
Press the Tilt buttom to activate the Tilt function (a yellow symbol appear at the right top corner of the screen).
Step by Step Angle Adjustment
v
Press the ^ ^ or button on the remote control to adjust the tilt angle of the screen one step at a time.
v
Continuous Angle Adjustment
^ ^
Press and hold the or
The angle adjustment can be adjusted by the right joystick up and down.
Aspect Ratio
Press the DISP button (28) on the remote control or WIDE/NAV button (2) on the monitor to adjust the aspect ratio as
follows:
v
button on the remote control to adjust the tilt angle in a continuous motion.
v
FULL
The entire screen is extended horizontally to the aspect ratio of
16 to 9. The extension ratio is the same at any point.
NORMAL
The conventional display image has a 4 to 3 ratio of horizontal to vertical,
leaving a blank area on the right and left sides of the display.
Image Setting
Table 2 shows the video output mode for each playing source.
59