La Sommeliere MILLESIME160 Gebrauchsanweisung Seite 38

The door will not close
properly
The code "HH" is displayed
on the control board
The code "LL" is displayed
on the control board
Replacing light
This appliance consists of light-emitting diodes (LEDs). This type of diode cannot be
changed by the consumer. The lifetime of these LEDs is normally sufficient for no
change to be made. If however, and despite all the care taken during the
manufacture of your wine cellar, the LEDs were defective, please contact your
after-sales service for any intervention.
Contraction and expansion of the inside walls may
cause popping and crackling noises
The wine cooler is not level
The wine cooler is not level
The door was reversed and not properly installed
The gasket is dirty
The shelves are out of position
If the temperature is too high (>30°C), the code "HH"
appears on the display and an audible alarm sounds.
The audible alarm can be deactivated immediately by
pressing the "on" / "off" button or by unplugging the
cellar. In this case please contact the after-sales service.
If the temperature is too low (<3°C), the code "LL"
appears on the display and an audible alarm sounds.
The audible alarm can be deactivated immediately by
pressing the "on" / "off" button or by unplugging the
cellar. In this case please contact the after-sales service.
37