Kress KG584 Bedienungsanleitung Seite 5

visually inspect to see, that
the fasteners are secure,
the housing is undamaged
and that guards and
screens are in place.
Replace worn or damaged
components in sets to
preserve balance. Replace
damaged or unreadable
labels.
3) OPERATION
a) Before starting the
machine, make certain that
the feeding chamber is
empty.
b) Keep your face and body
away from the feed intake
opening.
c) Do not allow hands or any
other part of the body or
clothing inside the feeding
chamber, discharge chute,
or near any moving part.
d) Keep proper balance and
footing at all times. Do not
overreach. Never stand
at a higher level than the
base of the machine when
feeding material into it.
e) Always stand clear of the
discharge zone when
operating this machine.
f) If the machine should start
making any unusual noise
or vibration, immediately
shut off the power source
and allow the machine to
stop. Remove the battery
pack from the machine
and take the following
steps before restarting and
operating the machine:
i) inspect for damage;
ii) replace or repair any
damaged parts;
iii) check for and tighten any
loose parts.
g) Do not allow processed
material to build up in the
discharge zone; this may
prevent proper discharge
and can result in kickback
of material through the
intake opening.
h) If the machine becomes
clogged, shut-off the
power source and remove
the battery pack from the
machine before cleaning
debris.
i) Never operate the machine
with defective guards or
shields, or without safety
devices.
j) Keep the power source
clean of debris and other
accumulations to prevent
damage to the power
source or possible fire.
k) Do not transport this
machine while the power
source is running.
l) Always disconnect the
machine from the power
supply (e.g. remove the
battery pack from the
machine)
EN
5