Technical Specifications; Operation - Gude GF 700 E Originalbetriebsanleitung

Package:
Protect against moisture
Interseroh-Recycling

Technical specifications:

Connection
Working revolutions
4 tiller blades/Ø 180 mm
Noise
Training
Please read carefully the Operating Instructions and the
servicing instructions. Learn thoroughly the controls and
proper using of the appliance. You must know how the
appliance works and how the controls may quickly be
switched off.
Never let children work with the appliance. Never let an
adult person work with the appliance without proper
training.
Do not let any persons, especially small children and pets,
to the place of your work.
Be careful to prevent slipping or falling.
Use as designated
For preparing earth on smaller and medium-sized areas.
For processing mulch, bog, sand, fertilizer or compost.
Works other than those for which the appliance has been
designed and that are specified in the Operating
Instructions cannot be performed with this appliance.
Any other use will be considered a use in conflict with the
designation. The manufacturer will not be liable for any
consequential damage and injuries. Please be sure to
know that this appliance has not been designed to be used
for industrial purposes.
This side up
Engine output
Operating width:
Weight
11
Assembly - pic. 2-5
Assembly of components, pic. 2-4
Take the electric tiller unit out of the container. Fit the
central columns with the star handle in the column outlet
on the engine housing (pic. 2). Insert nuts in the star
handles (included in the supply). Using cap head bolts
(included in the supply), mount the column to the
connection tube (pic. 3). Fix the cable on the connection
tube, leading from the switch-plug combination to the
engine, using the attached collar (pic. 4).
Extension cable strain relief hook, pic. 5
To avoid unintentional extension cable unplugging from
the switch-plug combination, please do not forget to put
the extension cable through the hook as appropriate (pic.
5).

Operation

Rotating knife unit
Perform any work/adjustment on the appliance only when
the engine is switched off, appliance unplugged and the
knife unit idle.
Putting the appliance into operation, pic. 6
Make sure the knives are not blunt and the knife holder
has no signs of damage. Start working only after
performing the above-mentioned steps. Replace any blunt
or damaged knives if necessary.
Unplug the appliance before any inspection.
To avoid unintentional switching-on of the electric tiller, the
switch-plug combination has been fitted with a safety
switch (pic. 6/A) that must be pressed before the switch
lever (pic. 6/B). When releasing the switch lever (pic. 6/B),
the safety switch (pic. 6/A) must get back to the original
position.
Make sure the extension cable is not within the operating
area of the knives. Press the safety switch (pic. 6/A) and
pull the switch lever (pic. 6/B).
The knives rotation direction guides the electric tiller away
from your body. The cultivation depth may be adjusted
(depending on the earth quality) by slowing down the
forward movement or pulling towards you.
These steps should be trained a couple of times to make
sure everything works perfectly. Start working only after
performing the above-mentioned steps.
Wait until the knives stop and unplug the appliance
before any adjustment or repair of your electric tiller.