Bosch BSA / SDL 4 Series Originalbetriebsanleitung Seite 63

6.2.2 Suspension tester SDL 43x
Step
1. Check prerequisites:
R
No vehicle on dynamometer!
R
Tester/test routine selected.
R
"Automatic" mode selected.
2. Drive onto the suspension tester with the axle to be
measured first and keeping the vehicle straight.
Press the brake to stop the vehicle moving.
3. Shaker plate motor starts up.
i
For axle measuring, the left side is measured first and
then the right side.
Robert Bosch GmbH
Automatic mode | BSA 43xx | 63
Result / Display
 Left: "Suspension tester" device symbol.
 Right: Drive-on prompt.
 Axle to be measured is positioned in suspension tes-
ter.
 Screen displays axle load (kg).
 Hour-glass starts to run down.
i
If the vehicle is removed from the suspension tester
before the hour-glass has run down, the axle weight is
stored (the suspension tester is only used to measure
the axle weight for a brake test).
"
Ready for chassis measurement.
 Screen indicates active shaker plate.
 Vehicle is caused to oscillate.
 Motor stops after approx. 4 seconds.
 Measurement commences.
en
|
1 691 606 210 2015-07-29