Cleaning And Maintenance - Westfalia 32 49 62 Bedienungsanleitung

4. Pay attention to the air hose while operating the spray gun. Hold the hose with
one hand while you are operating the spray gun with the other hand. The hose
must not be bent. Do not step on it, as this will lead to formation of droplets.
5. Press the trigger (4) to start spraying.
6. Release the trigger to stop spraying.
7. After work, disconnect the air tool from the air supply and clean it as described
in chapter "Cleaning and Maintenance".
Notes
Perform test runs on some test pieces. This way you can determine the
optimum spraying strength and the spraying distance.
Increase the distance to the object to be sprayed in order to achieve a wider
atomisation when spraying. By doing so, a more evenly spraying result can be
obtained.
Turn the nozzle (1) at the end of the spraying tube for a few turns clockwise or
counter clockwise to modify the spraying pattern. Use the counter nut (2) to
lock the nozzle in place.
Keep the nozzle and the suction tube clean at all times.
Do not process any abrasive, acid and fuel-containing materials.
Only use solvent-resistant and pressure-resistant air hoses (min. 10 bar).

Cleaning and Maintenance

Before cleaning or maintaining, first disconnect the air spray gun from the air
supply.
Depending on the sprayed material, rinse the spray gun with thinner or
cleaning agents after use. By spraying a small amount of detergent, suction
tube, nozzle and spraying tube can be cleaned from inside.
Add a few drops of oil to the sealing of the trigger pin in regular intervals. Apart
from that the air spray gun is maintenance free.
For operating pneumatic tools, clean air is required. Corrosion, residues, dust
and dirt from the pneumatic pipes reduce the efficiency of the tool and will
cause technical problems.
Use a moist cloth to clean the housing of the tool.
To clean the housing of the tool, do not use abrasive or aggressive chemicals
as benzene or thinner, which may dissolve plastic parts.
Using
12