Hart-Command 35 : Write Primary Variable Range Values; Hart-Command 38 : Reset Configuration Changed Flag; Hart-Command 40 : Enter/Exit Primary Variable Current Mode - ABB COPA-XE Betriebsanleitung

Erstellt von
Name: Holger Seebode
Datum:
9.7.1998

4.3 HART-Command 35 : Write Primary Variable Range Values

Request #0
Data Bytes #1..#4
#5..#8
Response #0
Data Bytes #1..#4
#5..#8
Response 0
Codes 2
5
11
12
13
Bemerkung

4.4 HART-Command 38 : Reset Configuration Changed Flag

Request none
Data Bytes
Response none
Data Bytes
Response 0
Codes 5

4.5 HART-Command 40 : Enter/Exit Primary Variable Current Mode

Request #0..#3 Fixed Primary Variable Current Level, IEEE 754, mA
Data Bytes
Response #0..#3 Actual Fixed Primary Variable Current Level, IEEE 754, mA
Data Bytes
Response 0
Codes 3
4
5
11
HART-Protokoll
Gerät: COPA/MAG-XE, 50XE4000
Software: HART-Software
Kennung: D699B180 X.10
Projektnummer:
PV Upper and Lower Range Values Units Code, Table II
Primary Variable Upper Range Value, IEEE 754
Primary Variable Lower Range Value, IEEE 754
PV Upper and Lower Range Values Units Code, Table II
Primary Variable Upper Range Value, IEEE 754
Primary Variable Lower Range Value, IEEE 754
No Command Specific Error
Invalid Selection
Incorrect Byte Count
Upper Range Value too High
Upper Range Value too Low
Upper and Lower Range Values Out of Limits
PV Upper Range Value
PV lower Range Value
No Command Specific Error
Incorrect Byte Count
No Command Specific Error
Passed Parameter to Large (> 24.8 mA)
Passed Parameter to Small (< 3.85 mA)
Incorrect Byte Count
In Multidrop Mode
Revision:
Name:
Datum:
= Qmax
= 0
0
Holger Seebode
9.7.1998
Revision
Revision
Revision
4-2