Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2 Installation and Wiring
2.1 EQUIPMENT HANDLING
2.1.1 Purpose -
information and procedures on installing and wiring
the Recorder. Included are handling procedures,
installation
and
wiring
instructions
for
both
equipment.
2.1.2 Initial Inspection -
when unpacking the instrument from the shipping
carton. The instrument is packed in a shock-proof
foam retainer to prevent damage during normal
transit.
2.1.3 Unpacking Procedure -
the following steps to unpack your Recorder:
•
Remove the foam retainer and instrument
from the shipping carton.
•
Carefully remove the instrument from the
foam retainer.
2.1.4 Detected Damage -
detected after unpacking the instrument, re-pack
the instrument and return it to the factory.
2.1.5 Storage -
before installation, re-pack the Recorder in the
shipping container. Cushion the Recorder with
foam molding or an equivalent and store in a cool,
dry area. We do not recommend storage of the
Recorder for more than one year
time is required, contact the factory for additional
storage information.
Siemens AG C79000-G7374-C211-01
SIREC D Manual
This chapter provides
specifications,
and
standard
and
optional
Exercise care
Perform
If damage is
For prolonged storage
.
If longer storage
2.2 INSTALLATION
2.2.1 Installation Environment -
Recorder is designed to operate the following
environment:
•
Indoor use only.
•
Temperature: Floppy/ 5°C to 40°C; PCMCIA
Card/ -10°C to 50°C
•
Humidity: 10 to 90% RH non-condensing
•
AC Power Required - 100 to 240 Vac, 50/60
Hz., 35VA.
NOTE
The Recorder is designed to be panel
mounted and as such should be considered
as permanently connected. Disconnection
from the supply must be possible via a
customer supplied switch or circuit breaker.
This disconnection device must be included
in the panel installation and should be
clearly marked, in close proximity to the
Recorder and easily accessible to the op-
erator.
2.2.2 Table Top Mounting -
recorder is designed to be panel mounted. It can
be used on a counter top by affixing the optional
rubber feet.
Installation and Wiring
The
The
2-1
Werbung
Kapitel
Inhaltsverzeichnis
