Werbung
| D-720(W, FS)
7.
Checking or replacement
of the components
can be done by
removing the bottom cover.
(Refer to Item 1, 'Bottom cover").
When
removing
the printed
circuit board,
however,
under-
3. Front panel
take the following procedure.
Remove the fixing screws.
See the printed circuit board approx. 1cm toward the front
panel.
(3) Remove the printed circuit board while lifting it at its rear.
83X25
eles
Fig. 20
@) Lift up
|
4. Knobs (DNL, DOLBY N.R., INPUT SELECT, MEMORY)
ig. 21
Pig
8. Deck chassis
Since the cassette deck chassis and the{ MAIN]
are connected
5. Upper cover
with the connector and pin-connector, remove
the deck chassis
after removing those connectors.
8T3X10
6. Lamp bracket
Werbung
