Herunterladen Diese Seite drucken

Sony VO-5630 Bedienungsanleitung Seite 4

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

On safety
e@ Operate the unit only with a power source specified in the
"SPECIFICATIONS" on page 24.
eShould any solid object or liquid fall into the cabinet,
unplug the unit and have it checked by qualified personnel
before operating it any further.
e@ Unplug the unit from the wall outlet if it is not to be used
for an extended period of time. To disconnect the cord, pull
it out by the plug. Never pull the cord itself.
On installation
eAllow adequate
air circulation
to prevent
internal
heat
buildup. Do not place the unit on surfaces (rugs, blankets,
etc.) or near materials (curtains, draperies) that may block
the ventilation slots.
eDo
not install
the unit near
a heat
source
such
as a
radiator or an
air duct, or in a place subject
to direct
sunlight, excessive dust, mechanical vibration or shock.
e@ The unit is designed for operation in a horizontal position.
Never operate the unit in a vertical position. The projections
on the connector panel are to protect the connectors and
switches on the panel when the unit is stored vertically.
e Keep the unit away from equipment with strong magnets
as for example a large loudspeaker.
On operation
eWhen the unit is not in use, turn the power off.
e@Remove
and
store
video
cassettes
after
recording
or
playback.
eNever operate the unit right after having transported
it
from a cold location directly to a warm location.
On cleaning
Clean the cabinet, panel and controls with a dry soft cloth,
or a soft cloth lightly moistened with a mild detergent solu-
tion. Do not use any type of solvent, such as alcohol or ben-
zine, which might damage the finish.
On transportation
@ Remove the video cassette when transporting the unit.
e@Save the original carton and associated packing material.
They will be useful should you have to transport or ship the
unit.
If you have any questions about this unit, contact your Sony
dealer.
TO PUT THE OPERATION PANEL ON A SLANT
The lower half of the operation panel can be pulled out as shown below.
To put the panel on a slant ~~
While pulling the projections
"~~.
on the bottom of the operation
panel out, swing the bottom of
the panel out and up until the
side braces lock.
«EI
SRO
ita sentic eras
Jug
Me,
__ To return the panel
be oatvot
~ to the original position
Push up on the side braces to unlock
them and swing the panel down and
back until it clicks into place.

Werbung

loading