Cleaning Side Brushes; Replacement Of Battery - Hyundai Homebot 3.0 Benutzerhandbuch

3. AUTO MOP
Press "MOP" on Apps or remote to start mopping. Assembly the mop
pad or mechanical water tank onto the unit before using this mode.
Under mop mode, the vacuum cleaning mode will stop working (no
suction power) and the mop route are the same as smart cleaning
routes.
4. MAINTENANCE

4.1 CLEANING SIDE BRUSHES

1. Please install the side brush at first use, align side brush and fixed
shaft and then press them.
2. Please clean side brush regularly and replace it if necessary.
*NOTE
When replacing the side brush, please grasp the soft rubber and pull
out.When installing, align the square hole of the side brush with the
side brush to fix the convex shaft, and press it gently to install it.
4.2 CLEANING THE DUSTBIN BOX AND FILTER
Please clean the dust box each time after working, cleaning steps as
following figures.
*NOTE
1. Take out the dustbin box and remove the HEPA filter.
2. Please gently shake the HEPA filter and clean it using the brush.
3. Clean the HEPA filter every15-30 days and replace it every 6 months.
4. Empty the dustbin box and clean it using the brush and/or wash it.
5. After having wiped all components, assemblethem being careful to
insert the Hepa filter into the housing
'
b
4.3 CLEANING THE INFRARED SENSOR AND CHARGING
CONNECTOR
Please use a dry and soft cloth to clean the infrared receiver and
charging connector as following figures.
*NOTE
1. Please clean the charging electrode on time to avoid charging issues.
2. Before cleaning, please make sure the power switch is turned off.
Clean the ground detection sensors and charging electrodes
Clean the infrared sensors
a b
c d
Clean the infrared signal emitter
Clean the charging electrode
4.4 INSTALLING AND USING WATER TANK
1. Insert the front part of water tank into mop cloth and paste mop
cloth with magic patch as following.
2. Open water filling nozzle and pour water into water tank.
3. Place the bottom of the unit upward, align the positioning column
of the water tank with the positioning hole of the unit and then press
the water tank.
Note:
1. The water will be leaked automatically once the water tank is filled
with water. Hence, please DO NOT leave the unit stay at the same area
for long time to prevent wet.
2. If you do not want to add water to the water tank. You could make
the mop wet for the mopping function.
3. The water tank can not stop leaking after water injection, please
remove it after each use or before charging orstorage.
4. Pay attention on water tank when using, add water or clean it on
time and remove it before adding water.
5. DO NOT to use water tank on carpet, when using water tank to mop
the floor, please fold the edge of capet to avoid foreign matter making
carpet dirty.
6. It is not suggested to add any detergent into the water tank. You can
add the detergent on the mop cloth.
7. After mopping, please dry the mop cloth to use it later.

4.5 REPLACEMENT OF BATTERY

Battery replacement of Robot
1. Release the screw with the screw-driver, open its base plate and
then take out the battery.
2. Please place the positive and negative electrode correctly for new
replacement battery.
3. Please set the Robot in charging state to keep the best of the
battery while the Robot is unused.
Battery replacement of the Remote controller
1. Open the battery cover and then replace the battery.
2. Please place the battery(not included) with correct polarity(+/-).
3. Please take out the battery if it was unused for long time.
1. Please DO NOT forget to take out the battery before discarding the
Robot.
2. Please turn off the power switch before taking out the battery from
the Robot .
3. Please DO NOT place the battery in High-temperature environment
above 45°C or in the water.
4. Please DO NOT exert external force to the battery or drop them
from heigh.
5. The battery should be recycled wit h safe disposal. Please DO NOT
discard it freely or throw it into fire for fear of explosion!
6. If the battery has leakage, avoid the liquid to skin or clothes, use
dry mop to clean it touched and send the battery to recycle bin or
mainteance service.